LETS.. FROM EARBUDS TO SPEAKERS !

0 comments

Assalamualaikum wrt dear readers. How was your recent winter holiday? Must be cool right? Anyhow, may those moments cherish your ukhuwwah among fillah’s friends and strengthen our faith to Allah by creating lots of beautiful and tranquil sceneries all over the world. Subhanallah.

InshaAllah today we will be sharing one idea of creating speakers, which in our opinion, very economical, less time needed, and useful, of course!

[Credit]
 http://www.doityourself.com/stry/from-earbuds-to-speakers


Things needed :

1. 4 polystyrene or plastic cups.

2. Hot glue gun of plastic glue.

3. One pair of used earbuds.

4. Scissors.

How to?

1. First of all, set your hot glue gun ready because it will take a lil bit time to heat up. Or you can simply use       plastic glue. (plastic glue no need to heat up haa)

[Credit]
 http://ecahabu.blogspot.com/2012/02/safety-lock-hendak-seribu-daya.html

2. Then, we have to make holes to 2 of our cups. Use a pencil to make a small hole at the cup center. Take        scissors, and snip your small holes into small X.

3. Gently push one of your earbuds through the "X" in one of your cups. Once the bud is through the "X" and      inside the cup, position the flaps back into place. Lightly pull back on the wire so that the back of the bud      is positioned against the bottom of the inside of the cup, and the top of the bud is facing out toward the          cup opening. Use your tape to secure the wire into place on the outside of the bottom of the cup. When        you have the first earbud properly positioned, push the second earbud through the "X" in the other cup.          Secure the wire with tape.

4. Create stands for your speaker with the second set of cups. Turn the cups upside down and place them          onto your surface. Apply a small amount of hot glue to the bottom of the cup. Carefully place one of your       homemade speakers onto the glued section of the cup. Hold it in place for about ten seconds. Apply glue       to the bottom of the second cup and position the other speaker into place. Hold it for about ten seconds        as well. This will ensure that the cup adheres to the glue.

[Credit]
http://www.newmodellersshop.co.uk/deluxe_materials.htm

5. If you do not have any disposable cups on hand, you can create the speakers with some thick paper.             Take a piece of 8X10 inch paper and fold it in half so that it is 8X4 inches in size. Cut the folded paper         into a semicircle. Unfold the paper and cut along the folded line so that you have two half-circle shapes.         Form the shape into a cone, leaving a small hole at the point. Secure the cone shape with tape. Gently           push one of your earbuds through the hole. Lightly pull on the wire so that the bud is positioned against the      paper. Tape the wire to the outside of the cone. Follow the same steps with the second earbud. Lay your     new speakers on your counter top.

6. Connect your earbuds to your device and turn the volume to the highest level possible.

Try it and let us know how it helps you! : )

Till we meet again, inshaAllah, thank you.


Post a Comment